# Bedside table
An esp8266 powered **IKEA Tvärfot** with a Neopixel ring and a proximity sensor.

![](https://external-content.duckduckgo.com/iu/?u=https%3A%2F%2Fwww.ikea.com%2Fbe%2Ffr%2Fimages%2Fproducts%2Ftvaerfot-table-lamp-black-white__0772756_PE756088_S5.JPG%3Ff%3Dxxs&f=1&nofb=1)

## Writing a configuration
Open a Serial Monitor at baudrate 9600 and paste the following json configuration adapted to your needs.
Before sending press the on board button "flash" or connect a button to D0. You will now have 10s to send the configuration. The onboard LED will light up as long as the board reads Serial input. If successful the new configuration should be shown in the terminal.

It is also possible to send the same json configuration on mqtt using topic *light/bedlamp/relay/0/config*. This of course demands that the ESP is connected to your wifi, logged in and registered on the mqtt service so this cannot be used for initial configuration.
```
{
   "hostname": "your_hostname",
   "ssid": "your_ssid",
   "wifipass": "[48...",
   "mqttserver": "mqtt.mydomain.com",
   "mqttuser": "mymqtt_user",
   "mqttpass": "7j%!fs#",
   "mqttport": "1883",
}
```

## OTA Updates
Configured in vscode, inside of *platformio.ini* change the board name to what you've set in the configuration. Then upload sketch updates via WiFi by clicking the *Upload* button in *platformIO* under the *evn:esp8266 OTA* configuration

## MQTT
### State and Command topics
An identical json package is both sent and received to set and get the status of the light. The command topic is ***light/bedlamp/relay/0/set*** and the state topic is ***light/bedlamp/relay/0***.

```
{
  "brightness": 255,
  "color": {
    "r": 255,
    "g": 180,
    "b": 200
  },
  "state": "ON"
}
```

### Configuration topic
See *Writing a configuration*. This can also be done using mqtt at topic ***light/bedlamp/relay/0/config***

## Home Assistant
Adjust the name and topics to suite your configuration
```
  - name: Bedside Lamp
    platform: mqtt
    schema: json
    state_topic: light/bedlamp/relay/0
    command_topic: light/bedlamp/relay/0/set
    brightness: true
    rgb: true
```